CONTROL BOXES SERIES “BC”

• The control boxes are made of EN 1.4301 (AISI 304) finely glazed. On demand they can be made of different type of stainless steel as well as customized.
• The container consists of an external case made of a sole bent sheet, thickness 20/10 with rounded corners, and of an internal case sealed by a special gasket, granting its protection level.. The upper part is bored to allow for the installation with the articulated arms BL-BJ and BS type. When the drilling prearranged on all control boxes for fixing to the joints is not used, the closure item TCB, made of AISI 304 S.S. can be supplied on demand.
• Two plates made of sendzimir are located in the upper and lower parts of the container as reinforcement. These plates are adequately shaped and bored to allow for the installation of supports, raceways and internal plates.
• Front and rear panels are made of flat stainless steel sheet thickness 2 mm. These panels are restrained in the gasket and fastened to the container with special screws polier M4, complete with sealing washers made of teflon.
• The front panel is equipped with a stainles steel handle.
• Pre-arrangement earthing complies with applicable rules.
• The containers belonging to this series can be pressurized according to the CEI31-1 standards, for safety installation AS-SI and for cases with internal over-pressure Ex-p.

ARTICULATED ARMS SERIE BL-BJ-BS

• The articulated arms are made of stainless steel tube AISI 304 with Ø 60.3 and thickness 3 mm. The surface tratement can be micropeening or mirror polish.
• The tube can be supplied bent in “J”, “S” or “L” form and with different dimensions, depending on customer’s requirements..
• Articulated or fixed joints can be welded, on demand, to the end of the tube.
• The max arm. carrying capacity with bending within 8 mm are: 40 kg for L.500 mm. and 12 Kg. for L.1250 mm.