CABLEDUCT SERIES “C”

• Made of stainless steel EN 1.4301 (AISI 304) fine glazed finishing
• Protection degree IP66 as per CEI EN 60529 rules
• All components are flanged to each another with oil-proof gasket in between..
• Each part comes complete with seal, set of assembling screws and ground stud bolt.
• STRAIGHT SECTION
Manufactured in several lengths, it is made of "C" metal section, complete with hinged lid with selfextinguishing oil-proof gasket and heavy-duty screw locks. For sections longer than 1.5 m the
lid comes in separate sections.
• TUBULAR STRAIGHT SECTION
Available for sections 60x60 and 100x100, it can be used in place of the straight section when inspection is not a must, and costs have to be kept low.
The partition baffles and the telescopic sections cannot be used with this particular series.
• TELESCOPIC SECTION
Tubular section. Used to compensate lengths from 50 to 500 mm. Tightness is guaranteed by locking the 0-ring supplied, between the mobile flange of the telescope and the fixed flange of the straight cableduct to be matched. In this case, the overall protection degree drops to IP54.
If separation baffles are used, the straight cableduct to which the telescopic section has to be matched shall then be equal to or longer than 1000 mm not to affect the adjustment possibilities of the telescopic length. If this is not possible, shortening becomes necessary.
• SECTION TO BE WELDED
Tubular element equipped with a flanged end and flange to be welded, for application to the part after cutting and shaping as required by the cableduct layout.
• FITTINGS
Bends 45° and 90°, "T" fittings, cross-joints and reduction of eccentric sections are available, all flanged and not inspectable.
• OTHER PARTS
The series is complemented by flanges for section reduction, either with central or eccentric drilling,
and head plates.
• SEPARATION BAFFLES
S/s sheets, "L" bent, available in 100x100 section, to divide the inspectable straight lengths into 2 sections. The slots for bottom fixing permit to change the two components as you like, no drilling being required since suitable stud bolts are provided. For lengths over 1000 mm, several separation baffles shall be coupled.
• SUPPORTING BRACKETS
Made of EN 1.4301 (AISI 304) in two versions:
a) Bracket type, for wall mounting
b) Hanging type, in 2 parts, for ceiling mounting
In case b), the two parts shall be connected by placing in-between a s/s pipe EN 1.4301 (AISI 304),
diam. 21.3, minim. thickness 1.5 mm (excluded from the supply), cut to the desired length, drilled
and bolted. For assembling on brackets, the cableduct must be screwed to the support.
Expansion bolts and rag bolts are excluded from supply.